Page 1 of 2
Ambicom CF not working
Posted:
Mar 7, 2003 @ 5:45amby Dihnekis
I can't connect with my ambicom CF card. I installed the software, did everything, and then tried to connect. The light stops blinking, signaling that i am in the range of the AP. I cant connect to anything though. I tried AIM, and I tried PIE, but nothing would connect. I have heard (from ironchef) that it wont connect because i was outside. i was outside of my friends house, about 100ft away. Any solutions? Also, i have my network connections set so my card connects through work, and when i try to change it to internet it wont work, it just goes back after i press ok.
Posted:
Mar 7, 2003 @ 5:55amby sponge
Check your card's config tool, see if it's getting an IP from the DHCP server (if your router even HAS a DHCP server)
If it does, then first try pinging a local IP (ie whatever PC is connected to your router) and if that works, try pinging a site like yahoo.com
Posted:
Mar 7, 2003 @ 2:29pmby Dihnekis
ok, but what do i do if it doesnt ping? I am not saying it didnt, i cant try yet. Anyone else got a solution?
Posted:
Mar 7, 2003 @ 5:58pmby Dihnekis
Posted:
Mar 7, 2003 @ 11:06pmby Dihnekis
Posted:
Mar 7, 2003 @ 11:17pmby Dihnekis
Posted:
Mar 7, 2003 @ 11:59pmby Dihnekis
ok, which driver should i get for my axim? CE 3.0 or CE .net for arm?
Posted:
Mar 8, 2003 @ 12:35amby damian
Posted:
Mar 8, 2003 @ 12:44amby Dihnekis
Posted:
Mar 8, 2003 @ 1:04amby sponge
If you can't figure that out, you REALLY need to RTFM.
Posted:
Mar 8, 2003 @ 1:26amby Dihnekis
Posted:
Mar 8, 2003 @ 1:30amby sponge
Posted:
Mar 8, 2003 @ 1:31amby Dihnekis
Posted:
Mar 8, 2003 @ 2:25amby Dihnekis
gonna try a hard reset
Posted:
Mar 8, 2003 @ 2:39amby damian
Try pinging someone on the local network and seeing if that works.