changing the processor
Posted: May 17, 2002 @ 5:10am
PocketMatrix
Mobile device developer community
http://pocketmatrix.com/forums/
changing the processor
Page 1 of 1
Posted: May 17, 2002 @ 5:10amPosted: May 17, 2002 @ 6:58amPosted: May 17, 2002 @ 7:43amPosted: May 17, 2002 @ 7:51amPosted: May 17, 2002 @ 9:20amPosted: May 17, 2002 @ 12:40pmLMAO
Posted: May 17, 2002 @ 4:28pmYou would need to able to do precision soldering on the silicon. Good luck! 
Posted: May 17, 2002 @ 7:10pmPosted: May 17, 2002 @ 9:17pmPosted: May 17, 2002 @ 9:21pmPosted: May 17, 2002 @ 11:47pmPosted: May 18, 2002 @ 2:30amthereticly it would work if the buss speed was the same or the xscale could automaticly reduce it's speed to adjust to the current bus speed, i.e 206 mhz.
Posted: May 18, 2002 @ 4:48amPosted: May 18, 2002 @ 5:20amPosted: May 18, 2002 @ 7:55pmMy thery is that you could change the processor, if you didn't mind it running at 206 mhz (i.e. underclocked). Isn't it the bus speeds that cause it to crash if you overclock these devices to 233? I thought that it was, but maybe it is a protection mechanism when the processor overheats?